Get matched with top drywall pros in Shelby, NE

Drywall does not necessarily need to be glued to the ceiling, especially when it is properly screwed or nailed into place. Drywall is typically attached to the ceiling joists using screws or nails, ensuring a secure and stable drywall installation. 

However, in certain situations where additional adhesion is required, construction adhesive can be applied in combination with screws or nails. This is often done for ceilings with specific acoustic or insulation requirements. It's essential to follow local building codes and best practices to determine if adhesive use is necessary for your specific project.

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Level 4 is the most commonly used drywall finish for visible interior walls. Finishing the drywall to Level 4 rovides a smooth surface ready to be painted with flat paint. 

Level 2 and 3 finishing are also common, particularly on walls that will get covered.

Yes, taping inside corners is a critical step in the drywall installation process.  Properly taping inside corners is essential for achieving a professional look, and an installation that resists cracking and maintains its integrity over time. Taping the corners involves the application of a joint compound along the seam where two drywall pieces meet. This process provides reinforcement, conceals the seam, and prevents future gaps or cracks from developing.