Get matched with top marble restoration pros in Plainview, NE

If the damage is minor, you can repair countertops without replacing them. You can also resurface a laminate countertop rather than replace it when it gets old and dingy. Countertop resurfacing is a relatively easy project, though it can be time-consuming, so you may prefer to hire a pro to do this for you.

You should always seal cut countertops to prevent damage and to keep them looking their best. The right way to seal countertops depends on the type of material. For laminate and wood, apply epoxy or other specialty sealers by pouring it onto the countertop and letting it flow across the whole surface to the edges, guiding it with a paint stick or putty knife. You will need to move quickly so that it does not dry or harden before you are done. For stone countertops, use a sealant specially manufactured for your type of stone and apply it according to manufacturer directions. 

You can resurface existing countertops as long as they’re not significantly damaged. Of course, it does depend on the material. Wood, natural stone, quartz, and even laminate are all good candidates for resurfacing. If you have tile, you may want to just replace the damaged tiles rather than resurface the entire countertop.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.