Best toilet pros near Ord, NE

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

You can DIY your toilet flapper replacement if you’re up for a small plumbing project. Turn off the water to the toilet, open the tank lid, remove the chain from the lever, and unhook the flapper. For a new, adjustable flapper, adjust it to the right setting according to your toilet's gallons per flush rating. Hook the flapper in place and install the chain with 1/2 inch of slack.

After flushing the toilet, you should have about half a tank full of water. While the exact amount of water you’ll have will vary, you want to make sure you have enough to cover the bottom of the bowl and enough to sit above the P-trap drain. While low water in your toilet bowl can indicate a problem, too much water can also be cause for concern.

To test for toilet leaks, use water coloring in the water tank and see if the water slips into the bowl from the tank. This test will indicate if there’s a problem with the flapper or refill tube. You can also put water coloring in the bowl of the toilet to see if there is a leak there. If there is, you should see the colored water on the outside of the toilet bowl or on the floor.