Get matched with top structural engineers in Hooper, NE

Because of their composite structure, cutting or drilling LVL beams can compromise their integrity. We strongly advise contacting a general contractor or structural engineer before making any alterations to LVL beams. Professionals can also answer questions about choosing between a pier and beam versus slab foundation when designing your project.

A 4-inch-thick concrete slab can support around 4,000 pounds per square foot if a contractor reinforces the slab with rebar, while that same slab without reinforcements will support closer to 1,000 pounds. For the purposes of a patio, 4 inches in thickness without reinforcement should suffice unless you’re installing heavy kitchen equipment or a hot tub on it. In those cases, reinforcing your slab and sticking with 4 inches of thickness should provide plenty of strength.

A structural inspection report will include a detailed description of the structural engineer’s findings, applicable photographs, and recommendations to correct the issue. The contents of the report may depend on the scope of the inspection but might also include a time and cost estimate for recommended work to correct any structural problems found during the inspection. 

Yes, you can put a doorway in a structural wall; in fact, most exterior doors are set into structural walls. The project is a little more challenging than installing a door in a non-load-bearing wall because you need a structural engineer to assess the wall and make sure it’s safe to create a wall opening. Your engineer’s report will include instructions for your contractor on how and where to install additional supports, like steel headers above the door, to distribute the weight above to the wall on either side of the door.