Top-rated boiler repair pros.

Best boiler repair pros near Walhalla, ND

Enter your zip and get matched with up to 5 pros

Need a pro for your boiler repair project in Walhalla, ND?

Select your specific project to find the pro for you.

Top-Rated Boiler repair pros in Walhalla - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Boiler or Radiator Heating System - Install or ReplaceBoiler or Radiator Heating System - Install or Replace - For BusinessBoiler or Radiator Heating System - Repair or Service+13 more

Serving Walhalla, ND and surrounding areas

In business since 1971

Credit card accepted

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Boiler Repair FAQs, answered by experts

The best time to buy home heating oil is in the summer when the demand is lowest, as the prices are usually lower. However, waiting until the summer to buy is often unavoidable unless you install a separate storage tank. If you have the space for a second tank, you can expect to pay between $1,000 and $4,000 for the oil tank replacement or installation, depending on the capacity and location. You could quickly recuperate these costs, though, by stocking up on heating oil in the summer and avoiding deliveries in the winter when prices are highest.

A furnace is a big unit where gas, heating oil, or electricity heats the air. The warmed air is then pushed back out through ducts and vents. 

A boiler uses electricity, heating oil, or gas to heat water that is pushed into the room through a radiator. This is one of the oldest and most effective ways to heat a house, but radiators can also be unsightly and leave hot and cold spots in the room.

Heat pumps use a refrigerant to move heat from outside into the house and return it to the room through ducts and vents.

In general, it’s a good idea to bleed air from your heaters at the start of every cold season, before you move your boiler system back into active mode. Early fall is a common time for this task. However, some heating systems don’t need much manual bleeding because of automatic bleed vents and other components.

Chilled water HVAC systems use water instead of traditional components and refrigerants. They're more common in commercial settings than residential ones but are slowly being adopted by some homebuilders to cool homes. As the name implies, the system keeps the water chilled at 40 degrees and circulates it through water coils. The water absorbs the heat from your home and drains outdoors. Condo apartments are more likely to have chilled water HVAC than single-family homes because this system is designed to cool several rooms or large areas individually.

Always consult your manual for specific pressure numbers. Many expansion tanks come pre-pressurized at a specific PSI range, anywhere from 12 to 40 PSI, designed for a range of home boilers. You should not have to pressurize an expansion tank yourself, only the boiler system. If your system has a tank that needs to be manually pressurized, this is generally a job for professionals and their tools.

The Walhalla, ND homeowners’ guide to boiler repairs

From average costs to expert advice, get all the answers you need to get your job done.