The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

No, a metal roof will not make your house hot. In fact, metal roofs help keep your home cooler by reflecting heat instead of absorbing and transmitting it inside. Metal also has high thermal conductivity, which means it gains and loses heat quickly. While the sun may heat the metal, the roof rapidly transfers that heat back into the air rather than retaining it. This reflective property can lead to energy cost savings of up to 40%, as your cooling system won't need to work as hard to maintain a consistent indoor temperature.

The easiest way to tell if your roof vent boot is leaking is to look in your attic for signs of water damage. You might see visible moisture, water spots, or mold on the roof decking around the roof vent or damaged or soggy insulation below it. If you don’t have access to your attic or aren’t sure if the vent boot is the issue, hire a professional to come inspect your roof and figure out the underlying issue.

Yes, it’s possible to replace drip edge flashing without removing shingles, but it’s not a good idea. You’ll have to lift the bottom shingles up to remove the old drip edge, install the new material, and then lay the lifted roofing material over the new drip edge. Bending roof shingles can cause damage, and if you have ongoing issues with roof leaks that prompt drip edge replacement, it’s a good idea to consider a roof and drip edge replacement to avoid ongoing issues.