Get matched with top deck and porch pros in Bottineau, ND

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

You can add a roof to most decks, but you need to have it inspected first. If your deck didn’t come with a roof initially, it may not be able to handle the weight without some structural changes. You can add additional supports to your existing deck to safely add a roof, and tying your deck’s roof to an exterior wall can help add some structural stability, but remember these aren’t DIY projects and need to be left to a pro. 

If you used regular jointing sand, you can typically walk on the repaired area right away. If you used polymeric sand, wait at least 24 hours before walking on it and 48 to 72 hours before driving over it, depending on the weather. Polymeric sand needs time to fully cure and lock the pavers in place.