Get matched with top pressure washers in Smithfield, NC

Does the water in your taps sometimes come out very slowly? If so, you might have problems with low water pressure in your house, and your pressure washer won’t effectively clean. To test if your water pressure is sufficient, time how long it takes for the water from your hose to fill a 5-gallon bucket. Usually, if it takes less than two minutes, you’re good to go.

You can certainly utilize a pressure washer to effectively clean your garage floor. If you're dealing with oily residue, consider adding a degreaser to the pressure washer solution. Prior to using the pressure washer, make sure to thoroughly sweep the garage floor to eliminate any loose dirt or debris.

Begin the pressure washing process from the back of your garage, which is closest to your home, and work your way towards the front. This ensures that the water and dirt are directed outside. In case you've applied a cleanser or degreaser, it's a good idea to give the floor another pass with clean water using the pressure washer to ensure a thorough rinse.

This process doesn’t necessarily require soap or detergent, but it definitely helps. You can get by with just using water, but remember, brick requires a lower-than-average pressure level when compared to concrete, so forgoing detergent increases the time it takes to spot clean stains and debris once you finish with the pressure washer. Brick is especially porous, so the less water you use on it, the better.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.