Get matched with top brush chipping pros in Point Harbor, NC

While tipping junk haulers is not required or expected, it is a greatly appreciated gesture for a job well done. Many junk removal companies state that tips are welcome but not mandatory. A good rule of thumb is to tip between 10% and 20% of the total bill, or a flat amount of $10 to $20 per worker. For exceptional service, a tip of $20 to $50 for the entire crew is also appropriate. It is often best to give cash directly to each worker at the end of the job.

Consider tipping if the crew:

• Goes above and beyond your expectations.

• Handles heavy, bulky items or navigates difficult spaces like tight hallways or stairs.

• Works in inclement weather or deals with potentially hazardous materials.

• Takes extra care to protect your home and property.

• Accommodates a last-minute scheduling change.

If you want to take the decomposition process into your hands to speed it up, water and sunlight are key. Of course, you can’t control sunlight yourself, but you can rake leaves into piles in sunny spots in your yard. In terms of using water, you can also moisten the decomposing leaves with water, whether by pouring some from a watering can from time to time or using a hose to moisten them.

While you can leave roots in the ground, if you don’t want the shrub to regrow again over time, it’s best not to leave any roots behind. Ensure you remove as much of the shrub as possible, including the root ball and any main roots you can see, to prevent new growth. Some gardeners opt for using a chemical treatment to prevent the stump from growing back, but this can kill beneficial microorganisms living in your soil.

Depending on the method you choose to remove grass, it may or may not matter whether the grass is wet or dry when you perform the task. A dryer lawn will be easier to negotiate with a sod cutter, especially if you're not planning to reuse the turf. However, using a shovel by hand might be a little easier if the ground is slightly damp but not so much that it sticks to the tool.