Get matched with top pressure washers in Kill Devil Hills, NC

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

It takes about 15 minutes per each side of an exterior house to apply detergent and 15 minutes to remove it, so you’ll need roughly two hours for the whole job. However, that length of time may decrease or increase depending on the size of your home, so always budget a little more than expected to ensure you don’t end up rushing to get it done.

It‘s risky to pressure wash indoors, and we wouldn’t recommend it, but following all safety guidelines can prevent the worst outcomes. Always make sure to use an electric-powered machine over one that’s gas-powered, remove obstacles that could cause tripping or falling, and keep appliances like hair dryers and toothbrushes unplugged and out of the way to prevent electrical hazards. 

Yes, pressure washing a wood deck can be a good idea as it effectively lifts ingrained dirt, mold, and mildew, improving the deck's appearance and longevity. However, it must be done carefully, as it's easy to damage the wood, especially softwoods. To pressure wash safely, use a lower pressure setting and a wide, 40-degree fan pattern nozzle (often white). Keep the nozzle at least a foot away from the wood surface and maintain constant motion, avoiding hovering in one spot to prevent gouging.