Get matched with top gas leak repair technicians in Cerro Gordo, NC

Yes, it’s possible to convert an oil furnace to gas. However, you may have to replace the furnace completely instead of simply converting it. If the original oil furnace has had any type of damage or is older (typically considered over 15 years old), then you will likely need a full replacement versus a conversion.

Shut-off valves, like any other piece of metal hardware, can corrode, age, get worn down, and eventually break or rust into place. Occasionally spray your shut-off valve with WD-40 to stall it from rusting. If it really gets stuck, a wrench and WD-40 will usually do the trick, but you will need to call a plumber if it’s completely unmovable.

Even though their jobs sound similar—both professions work on pipes—a plumber and pipefitter actually have very different jobs, and pipefitting isn’t considered plumbing. Pipefitting is done in commercial and industrial buildings and factories, and the pipes carry gas, chemicals, acid, and other potentially hazardous substances. Pipefitters often work in intense conditions while plumbers may work in lower-pressure environments.

This is a matter of personal preference, as each method has its own pros and cons. Oil furnaces are safer, but the smell can be off-putting to some consumers. Oil is also more expensive than gas. However, oil furnaces boast a higher BTU rate per hour, so a smaller amount of oil can heat a larger space when compared to a gas furnace.