Get matched with top mailbox repairers in Calypso, NC

There are a few reasons that a drawer won't come out. Most of the time, there's an obstruction of some sort preventing the drawer from acting normally. The key to figuring out the problem is investigation and patience. 

If possible, open the drawer as far as it will go and shine a flashlight inside to see if something in the drawer is hitting the cabinet frame. Or, remove a drawer above or below the offending one and use the flashlight to investigate the drawer slides. Discovering the cause will likely provide the necessary information to develop a solution.

When deciding whether to reupholster, repair, or replace old furniture, consider its age, level of wear and tear, and overall value. It’s usually better to repair old furniture because older pieces tend to be made out of hardwood, like oak and maple, whereas newer furniture is more often made out of plywood, medium-density fiberboard (MDF), and other less durable materials. When determining whether it’s worth the price to repair a furniture item, calculate the price of buying a new, similar piece and compare that to quotes from local furniture repair services.

In most cases, it is more affordable to reupholster furniture than it is to replace it, but it depends on the quality and age of the furniture you’re considering getting reupholstered. Antique pieces are always worth reupholstering, as it’s the only way to preserve the piece and extend its life. Newer pieces of furniture are more often made using lower-quality materials like medium-density fiberboard or plywood that don’t have the same lifespan as things like hardwood. For newer pieces, your furniture reupholstery specialist should be able to help you determine the best course of action.

Yes, you can fill rotten wood with expanding foam. You may prefer using an expanding foam treatment instead of wood filler since the latter can take a long time to dry. It may also provide an easier solution when you’re dealing with smaller gaps. If you use expanding foam, allow it to cure for about 24 hours before you sand and prime it.