Get matched with top fencing pros in Ekalaka, MT

In most cases, you will need a building permit to put up a vinyl fence, especially if the fence is sitting on or close to your property line. You can ask your local building department or  fence installation company if your fence project will require a permit. If so, you can expect it to cost between $20 and $60. Your fence installer should pull the permit for you. Building without a permit could eventually require you to pay again to remove the fence and reinstall it after getting the job approved.

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

Traditional bamboo fences use twine to attach pickets to posts and stringers, but you have to keep an eye on the twine, as it will deteriorate over time. Alternatively, you can fasten bamboo pickets to framing using fence screws.

You’ve likely been considering lots of wood fence ideas for your yard. There are many reasons why people choose split rail fences time and again. For one, they’re one of the most wallet-friendly fencing options, especially since you don’t need to use much hardware and setting the posts doesn’t require concrete or foam. So if you have a large property and want to fence it in, your best bet may be a split rail fence.