Get matched with top fencing pros in Carlile, WY

When it comes to materials, wire fences are the cheapest option. The average cost for a 150-foot wire fence is $1,350. The next cheapest material is chain-link, followed by wood.

As far as the style of fence, smaller, less private fences are cheaper than large, elaborate fences that block your whole yard. That’s why split-rail fences are the cheapest option for wooden fences. They cost roughly $10 to $30 per linear foot.

Whether you need a permit to build or install a fence depends on several factors, including your location, the fence's height, its placement in your yard, and the materials used. In many cities and highly populated areas, a permit is required, especially for fences taller than 6 feet. Conversely, rural areas may have fewer restrictions. Typically, backyard privacy fences 6 feet or shorter do not require a permit, while front yard fences often have a lower height limit, sometimes as low as 3.5 feet. There can also be exceptions for properties in mixed residential-commercial zones. It's best to check with your local building inspection or zoning department to understand the specific requirements, height restrictions, and location rules for your area. A professional fence installer can help you navigate this process and often secure the necessary permits for you, though this may extend the project timeline.

Corrugated metal is a strong, long-lasting material. A corrugated metal fence will typically last several decades, and the metal panels themselves may last for 40 to 60 years. The main thing you should be concerned about is the fence posts. Wood fence posts will last about five years if you purchase them untreated or about 15 years if you treat them after installation. Keep an eye on your posts and look out for insect damage and rot.

Staining a fence is less expensive than painting a fence due to the cost of materials and the longevity of the finish. Stain not only lasts longer than paint without chipping or peeling, but you also won’t have to put in the extra time and cost to prime the surface first.