Top-rated toilet pros.

Get matched with top toilet pros in Colstrip, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Colstrip, MT?

Select your specific project to find the pro for you.

Find Toilet pros in Colstrip

Avatar for TCH Builders & Remodeling
TCH Builders & Remodeling
4.0(
2
)

Serving Colstrip, MT and surrounding areas

In business since 1999

Emergency services offered

Credit card accepted

If you dream it, we can build it. What's the biggest difference between us and them? We build to last! We offer a full line of Green and Energy Star Certified products, backed by our labor and manufacturer's lifetime transferable warranties. Credit Cards Welcome Financing Available OAC.

Recommended by100%of homeowners
Toilets questions, answered by experts

The toilet should rest 10, 12, or 14 inches from the back wall. As for other clearances, 15 inches is the minimum distance from the flange to any side wall or nearby fixture, including the shower, tub, and sink. Modern codes also require at least 24 inches of clear space in front of the toilet.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

Yes, you’ll need to replace your toilet’s wax seal any time you move the toilet. This is because movement of the toilet will break the seal, rendering the remaining wax useless. Thankfully, replacing a wax seal is fairly easy, and the seal itself only costs $2 to $10 at most home improvement stores.

When replacing a wax seal you typically also have to replace the closet bolts that secure the toilet to the flange. These are usually about 2.5" - 3" long and have to be cut once the toilet is secure. Cutting them usually makes them too short to reuse.

If you notice water coming out of the bottom of your tank or the flush handle, you obviously have a leaking tank. Water on the side of the tank can indicate cracks. Other signs include the toilet running and flushing without anyone touching the handle, needing to jiggle the handle to make the water stop after flushing, or needing to hold the handle down to empty the water tank.

If you’ve accessed the bolts and nuts that hold your toilet seat in place and can’t unscrew them, it’s possible that they were overtightened or that the material corroded over time, making it impossible to unscrew. If that’s the case, you can either call in a plumber for help, or you can DIY a solution if you’re careful. Lay down masking tape around the mounting bracket and then use the tape as a surface to lay a hack saw blade. Move slowly to cut through the bracket and bolt, being careful not to damage the porcelain in the process.

The Colstrip, MT homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.