Get matched with top foundation drain installation pros in Robinhood, MS

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

Yes, it’s possible to install a sewage ejector pump outside rather than in a basement. However, there may be some extra steps involved, including running pipes from the inside to the outside of your home and digging (and re-filling) a hole for the basin. If you aren’t comfortable with this type of work, contact a plumbing pro to handle it for you.

Some questions you should ask before hiring a plumber or drainage installation company include:

• Are you licensed and insured?

• Do you have any customer testimonials I can read?

• How do you handle unforeseen challenges that occur during the job?

• Is your fee a flat rate or hourly?

• Do you do the work, or do you have subcontractors?

• Is everyone who does the work licensed and qualified plumbers?

• Is cleanup included in the quote?

• Do you offer a warranty or guarantee on your work?

A sump pump can be added to an existing basement. To do this, you will need to use a jackhammer or sledgehammer to break up the concrete and dig a pit. You will also need to create a hole in your basement wall to run the discharge pipe through.