Top-rated electricians.

Get matched with top electricians in Bruce, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Bruce, MS?

Select your specific project to find the pro for you.

Find Electricians in Bruce

Self Electric
4.6(
34
)
Fixed Generator - InstallCeiling Fan - InstallCeiling Fan - Repair+17 more

Serving Bruce, MS and surrounding areas

Approved

In business since 2005

Free estimates

Credit card accepted

"I used Self Electric to have 7 outlets installed and they also wired in two new breakers. Their quality of service is 5 star. They are fast, friendly and affordable. They are also flexible with your schedule. I recommend them to anyone. If I ever need electrical service again I won't hesitate to call Self Electric."
Response time1 day
2 neighbors recently requested a quote
Recommended by100%of homeowners
...
Showing 1-10 of 138
Electrical questions, answered by experts

A multimeter does not measure frequency, charge, inductance, and other electrical quantities. Instead, it measures voltage (AC and DC), current, and resistance.

The main reason outlets become loose is because the contact points have started to wear down after years of use. Occasionally, poor wiring can cause heat or sparks that can damage the outlet and cause it to become loose. Either way, if your plugs slide out after being inserted into the outlet, it’s time to replace it.

GFCI stands for Ground Fault Circuit Interrupter, a standard safety addition to home power outlets. In rooms where moisture is more likely, like the bathroom and kitchen, GFCI outlets stop the current when certain kinds of shorts are detected, preventing shocks. Both GFCI and the similar AFCI (Arc Fault Circuit Interrupter) outlets are polarized and have clear indicators on the receptacle where hot wiring should go.

You can identify Federal Pacific Stab-Lok® breakers by the label on the front of the panel that says “Federal Pacific” or “FPE” and the breaker itself should say “Stab-Lok®” either on the face of the panel or a label inside the panel door. The Stab-Lok® breakers are also usually red on the breaker switch.

A 10,000-watt generator can run a small to mid-sized central AC unit (typically up to 3 tons or 36,000 BTU) along with a few other appliances. However, larger AC units or additional loads will require a bigger generator. Consult a local generator installer to ensure you add the correct size generator to your home.

The Bruce, MS homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.