Get matched with top electricians in Unionville, MO

You will need a permit for any electrical work that involves installing or replacing wiring, moving or installing new fixtures, switches, or outlets, hardwiring appliances or HVAC equipment, installing subpanels, and upgrading electrical service. You typically don’t need a permit to have an electrician replace an existing light fixture or electrical box. You can always call your local building department to see if your project needs a permit, but a professional electrician will be able to tell you. In most cases, your professional will pull the permits for you.

While washers and dryers do not require a GFCI (ground fault circuit interrupter) outlet to function properly, electrical codes often mandate their use for safety. The National Electrical Code (NEC) requires GFCI protection for all outlets within six feet of a water source. This means a washer and dryer must be plugged into a GFCI outlet if they are installed in locations like a laundry room, utility room, garage, or basement. In other areas without a nearby water source, there is no specific requirement, but using a GFCI outlet is still recommended for extra peace of mind. It is always best to consult your local codes and regulations to ensure compliance and safety.

Well pumps need power to run, so they can’t function without electricity. If your power shuts off, there can sometimes be enough pressure in the water tank to allow for a lucky flush or a bit of tap water—but this won’t last long. It’s a good idea to have a backup generator or an alternative power source like solar if you’re worried about losing power.

A bigger breaker alone probably won’t fix your problem of frequent tripping. But if you upgrade an electrical circuit to a higher amp rating, or upgrade your breaker box to handle more amps, it could solve your tripping problems. Consult a qualified electrician about the best course of action.