Get matched with top sink installation pros in Princeton, MO

In many ways they are the same thing, which is a large sink that has a tall front section, often called an apron. This is because the depth of the sink prevents splashing against you, serving the same purpose as an apron. While all farmhouse sinks are apron sinks, not all apron sinks are farmhouse sinks.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

If your sink is on an exterior wall that isn’t insulated, or if pipes travel through a cabinet against an exterior wall that prevents heated air from circulating around the pipes, the pipes can freeze, causing them to burst. The best way to avoid leaking sinks is to insulate the pipes and open cabinets in the short term to warm the water line up and prevent freezing.