Get matched with top concrete resurfacing pros in Duquesne, MO

For cracks in asphalt driveways, you can use crack filler or cold-patch asphalt mix, while concrete driveways can be repaired with a concrete patch or resurfacer. To fix the driveway cracks, apply the filler directly into the crack using a caulker and then level it with a putty knife.

To improve the appearance of concrete steps, you can repair any damage, refresh the surface, and add decorative elements. For crumbling, chipping, or broken sections, consider concrete resurfacing or light repair. If the surface is intact but discolored, applying a coat of paint, stain, or concrete sealer can refresh its look; reapplying a sealer every one to two years is recommended for maintenance. For a quick enhancement, you can also add decorative items like potted plants, garden statues, lanterns, or decorative railings to spruce up the area.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

Yes—as long as the area has been properly prepped. Different self-leveling brands and compounds have their own specific instructions for preparation; some may require that you add primer or grind the surface. Without proper preparation of the surface, the compound will not be able to fully bond to the concrete and fill the cure as a separate layer, which makes it prone to chipping.