Top-rated water heater pros.

Get matched with top water heater pros in Willmar, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your water heater service project in Willmar, MN?

Select your specific project to find the pro for you.

Find Water heater pros in Willmar

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Solar Water Heater System - InstallTankless Water Heater - InstallTankless Water Heater - Install - For Business+6 more

Serving Willmar, MN and surrounding areas

In business since 1971

Credit card accepted

"We pay yearly but we have this is included with our rental property. They are pretty good on most things. We had a hot water heater replaced and they did an excellent job on that. They are very quick on their response. They dont come out here. It is all done on the internet.  I just like the idea that one time service charge is so much better than trying to hiring someone to come in. It is more about convenience. It pays for itself."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Water Heaters questions, answered by experts

Unless they are connected to the same system, boilers and water heaters will both need their own expansion tanks. The only case they wouldn’t have separate expansion tanks is if the boiler is pulling double duty and managing a heating system while also supplying hot water for a home. In which case, you may not need a hot water heater.

No, boilers and water heaters are not interchangeable because they serve different primary functions. Boilers are used for central heating systems, providing hot water or steam to heat your home. In contrast, a water heater's purpose is to supply hot water for daily household use, such as for faucets and showers. A water heater alone cannot supply the warm water or steam needed for a central heating system.

While they are not interchangeable, it is common to have both a boiler and a water heater. In fact, a conventional boiler often works best when a water heater system is already in place. The two systems can be combined to provide both heating and hot water, either by pairing a boiler with an indirect water heater or by installing a premade combination boiler-water heater unit. For home heating, some homeowners may also opt for a furnace instead of a boiler.

The standard copper wire gauge to use with any 30-amp circuit is a 10-gauge wire. The National Electric Code specifies a 10-gauge wire with appliances like water heaters running on 30 amps. If you try to use a smaller gauge wire, such as a 12 gauge, with a 30-amp breaker, you run the risk of the wire overheating and melting or causing a fire. Because of the safety hazards, the gauge of the wire is not an area to try to cut costs when connecting a 30-amp breaker to a water heater.

We recommend you turn off the unit, the power, and the water supply as soon as you notice a leak. Your water heater tank should have a dedicated shut-off valve located on the cold inlet pipes. If the valve is broken or inoperable, use the shut-off valve to your home's main water supply to stop the flow to the entire house.

Avoid touching valves or pipes directly without confirming if they are hot. Wear gloves and other safety gear to keep from coming into contact with hot levers or components when turning off your leaking water heater.

The average water heater holds between 40 and 60 gallons, but the exact amount of water that comes out during draining will depend on your unit’s capacity. The amount of time it takes to drain a water heater averages from 10 to 30 minutes.

The Willmar, MN homeowners’ guide to water heater services

From average costs to expert advice, get all the answers you need to get your job done.