Get matched with top roofers in Holdingford, MN

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

Metal roofs do not inherently leak more than shingle roofs; when properly installed, they are generally less likely to leak. Asphalt shingle roofs are more susceptible to leaks due to factors like wind uplift, damage from extreme weather, moss growth, and ice dams. Over time, asphalt shingles also lose their protective grit, which reduces their waterproofing capabilities. In contrast, metal is a more resilient material that stands up better to heavy precipitation and high winds. However, metal roofs can develop leaks if they are poorly installed, have improperly sealed fasteners, or experience issues from thermal expansion. For this reason, professional installation and regular maintenance are crucial to ensure a metal roof's longevity and superior protection against leaks.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Yes, shingles should overhang the drip edge, typically between 1/2-inch and 3/4-inch. An overhang shorter than 1/2-inch can allow wind-driven rain to get under the shingles and damage the roof deck or fascia. Conversely, an overhang longer than 3/4-inch increases the risk of shingles getting caught by strong winds, which can lead to roof uplift. Always check your local building code for exact overhang requirements in your area.