Get matched with top epoxy flooring pros in Hallock, MN

Flooring professionals can typically apply epoxy within one or two days, depending on how much preparation or repair the old floor needs before application. However, you’ll need to wait after the application is complete to use the flooring. While you can walk on the epoxy flooring before it fully cures, it can take up to 72 hours for the epoxy floor to fully dry and be ready for full use.

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

Concrete is extremely porous. Without a proper sealing, it will absorb just about anything it comes in contact with, including water and ice. During the colder months with freeze-thaw cycles, this could cause the concrete to crack and become damaged in other ways. You always want to seal your cleaned concrete surfaces after they’ve completely dried out.

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.