Get matched with top water heater pros in Goodview, MN

It takes between one and three hours to replace a hot water heater element, depending on whether you hire a pro or do the work yourself. For example, a professional plumber with all the necessary tools and experience can often finish the job in one to two hours, whereas DIY will take two to three hours because it'll involve more preparation and troubleshooting.

While a water heater explosion is rare, it is a serious danger. Be aware of these critical warning signs:

• Sulfur or Rotten Egg Smell: This is a major red flag, especially for gas water heaters. It can indicate a gas leak, which could ignite and cause an explosion.

• Leaking Pressure Valve: If the temperature and pressure (T&P) relief valve is leaking, it may not be able to properly regulate internal pressure, creating a risk of bursting.

• Shaking or Rumbling: Loud rumbling or shaking from the tank can be a sign of extreme pressure buildup.

• Excessive Heat: If the exterior of the water heater feels unusually hot to the touch, the unit may be overheating dangerously.

• Rust-Colored Water: This can be a symptom of severe internal corrosion that compromises the tank's integrity.

If you notice any of these signs, especially a gas smell, you must act immediately. Shut off the gas supply to the water heater and call a professional plumber right away to prevent a potential disaster.

Homeowners insurance may cover the repair or replacement of a water heater if it's damaged by a covered peril, such as a fire or a burst pipe. However, policies typically do not cover repairs or replacement needed due to normal wear and tear, old age, or lack of maintenance. For these issues, a home warranty or a manufacturer's warranty may provide coverage. While the policy might not pay to fix or replace the malfunctioning appliance itself, it often covers the cost of water damage restoration caused by the faulty water heater. Always check with your insurance provider to understand the specifics of your policy.

Yes, most municipalities have codes that require water heaters to have pans. A pan is necessary when a water heater or hot water storage tank is installed in an area where water leakage could cause damage, such as an attic, second floor, or finished basement. Tankless water heaters are not required to have a pan since there is no storage tank.