Get matched with top fencing pros in Brandon, MN

Privacy fences in residential neighborhoods tend to stand between 6 and 8 feet tall, but local building code usually dictates the maximum height. Livestock fences that border large land plots range from 3 to 6 feet. Shorter, decorative fences, which are common in front yards, are around 3 feet tall, on average. Fence height also tends to vary by material, with wood fences usually sitting at 6 feet tall, and chain-link and wrought iron fences tending to sit at half that.

Who pays for a new fence between neighbors depends on its location relative to the property line. If you build the fence entirely on your property, you are solely responsible for the costs of installation, maintenance, and repair. If the fence is built directly on the property line, both neighbors are typically responsible for the costs. In this case, it is essential to consult with your neighbor beforehand to agree on a plan for payment. While you should always inform your neighbor of your plans in advance, you generally cannot force them to contribute financially unless there are specific local laws, such as in California, where both parties might be responsible for costs unless a different agreement exists. It's a good idea to get a property line survey to know the exact boundaries before building.

A silt fence should be buried in a trench that is 6 to 12 inches deep. A depth of at least 6 to 8 inches is necessary to prevent water and sediment from running underneath the fence. A deeper trench, up to 12 inches, provides better anchoring during wet and windy weather. To ensure proper installation, look for a red line on the silt fence fabric, which often indicates the correct burial depth. Always adhere to local guidelines and regulations; a professional contractor will be familiar with these requirements.

On most untreated wood fences, there is no need to sand before treating. You typically only need to sand if there’s an old coat of paint or stain on your fence. If you do need to sand off a previous paint or protective coating (like an old stain or sealant), use medium-grit sandpaper.