Get matched with top stucco pros in Amboy, MN

Most homeowners can remain in their homes during stucco removal, but expect noise, dust, and limited access to certain areas. For extensive projects or if hazardous materials are present, temporary relocation may be recommended for safety and comfort. Before removal begins, seal off the work areas and use air purifiers to minimize the spread of dust.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Stucco will dry in two to three days, but you should wait one to two months to allow it to cure fully before you paint it. The curing process is slow, but leaving the material exposed to air and natural moisture will help it reach its maximum strength. If you live in a hot, arid climate, wait a month before painting. Wait two months before painting if you live in a more moderate or wet climate.

It’s not advisable to use CLR on stucco. CLR is a powerful acidic cleaner designed for removing tough mineral stains. Stucco is a porous material commonly made of cement, lime, and sand. The acidic nature of CLR can potentially damage or etch the stucco surface, leading to discoloration or deterioration. 

It is best to use cleaning solutions specifically formulated for stucco or mild household cleaners mixed with water to clean stucco siding. Always test any cleaning product in a small, inconspicuous area before applying it to the entire stucco surface.