Get matched with top roofers in Oak Park, MI

Building an A-frame roof falls under the category of constructing a steep roof. While its structure is relatively simple, its height and requirements for more materials than a shallow roof design can increase its cost significantly. Expect prices for building an A-frame roof to hover around average to slightly above average.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

Architectural shingles typically last between 20 and 30 years. While some manufacturers provide warranties for 30 to 50 years, particularly for extreme weather, achieving such a long lifespan is uncommon. The actual life of your shingles can be shorter if you live in an area prone to strong winds, hailstorms, or other severe weather. To avoid the risk of roof failure and costly water damage from leaks, it is recommended to replace your roof before it reaches the end of its expected life. Scheduling regular roof inspections every few years is a good way to assess your roof's condition and determine the best timeline for replacement.

The ridge is the horizontal line where two sloping roof sections meet at the top, forming the highest point of the roof. A hip, on the other hand, is the external angle formed where two roof sections meet and slope downward toward the walls, typically at a lower angle than the ridge. The ridge runs horizontally along the peak and the hip runs diagonally from the peak to the roof's edges.