Get matched with top roofers in Merritt, MI

Venting a gas water heater out of the roof is preferable in most cases. Heated exhaust gases naturally rise, so a vertical vent pipe is efficient. If you’re trying to vent through a pipe exiting a wall, the angle of the pipe may be more horizontal than vertical, making the venting system less effective. If you go through a wall, you may need to add a fan to ensure a successful expulsion of the gases outdoors.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Yes, clay and concrete tile roofs will keep your home cooler in the summer for two reasons. First, the material has low heat conductivity, so heat transfer from the sunlight and the outside air to your home will be very slow. Additionally, tile roofs have air gaps between the tiles and the roof decking, which helps further insulate your structure from heat gain. Light-colored tile is especially energy-efficient and will minimize how much outside heat transfers into your home.

In most cases and locations, roofs with a single layer of asphalt roofing shingles won't require roof removal before installing a metal roof. However, underlayment may be necessary on roofs with moderate shingle damage. Heavily damaged roofs or ones with multiple shingle layers will most likely require removal before a metal roof can go on.