Get matched with top roofers in Evart, MI

Asphalt shingles are the least-expensive roofing material. They cost around $10,000 for a 1,600-square-foot home compared to $16,500 for metal roofing or $25,000 for slate shingles.

The most common slope range for roofs on houses in snowy areas is between 4/12 and 6/12, or 50%. A roof with a slope of less than 10%, or roughly a 2/12 pitch, won’t be effective at shedding snow. However, roofs that are too steep can allow large amounts of snow to build up and fall all at once, creating a hazard for those on the ground.

Yes, roof ridge caps are a necessary part of your roof system. Your roof ridge cap is at the peak of your roof, where two slopes of your roof meet. Roof ridge caps seal the seam and help protect your roof from water and debris, and because they’re pre-bent and thicker, they’re more suited to the job than regular roof shingles, which can break when bent.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.