Get matched with top insulation pros in Clarklake, MI

To cover your HVAC ducts and air vents during construction, use plastic sheets or drop cloths secured with painter's tape. Be sure to cover all supply vents on your floors and walls, as well as the larger HVAC return vent, which is typically on the ceiling. While canvas drop cloths can also be used, they may not catch all the fine dust. It is crucial to shut off your HVAC system or at least the zone where construction is happening. Running the system with vents sealed can put significant strain on the blower motor and air handler. For additional dust containment, you can also hang plastic sheets over doorways to separate the construction area from the rest of your home.

Whether you should remove old insulation before blowing in new insulation depends on your particular situation. Fiberglass insulation attracts insects and mold over time, so if it has been decades since your last insulation upgrade, consider removing the old materials before placing the new ones. However, most types resist mold, insects, and mildew, so once you get the go-ahead from your contractor that your space is free from all three, feel free to install the new insulation directly on top of the pre-existing materials.

Ideally, you can add new insulation to your existing insulation. However, some circumstances require you to remove old insulation before adding any new insulation: 

• If the insulation is over 15 years old

• If the insulation is wet or moldy

• If it is vermiculite insulation

• If you see signs of pest infestation

Removing old insulation is best left to a pro who can safely dispose of potential moldy or asbestos-ridden insulation.

Unfaced wall insulation is easier to cut and install, making it the better choice for a DIY project. It’s also more affordable. But if it’s unfaced, you’ll likely need to add a vapor barrier to reach your desired R-value and efficiency, as it doesn’t offer any moisture barrier.

Faced insulation uses paper or foil to create a built-in barrier and doesn’t require an extra step. It’s also more fire-resistant and safe. But it’s quite a bit more expensive and a little bit harder to work with as a DIYer.