Get matched with top pressure washers in Britton, MI

This process doesn’t necessarily require soap or detergent, but it definitely helps. You can get by with just using water, but remember, brick requires a lower-than-average pressure level when compared to concrete, so forgoing detergent increases the time it takes to spot clean stains and debris once you finish with the pressure washer. Brick is especially porous, so the less water you use on it, the better.

No, you should not use a pressure washer or power washer on roof shingles, including asphalt shingles. The high water pressure is too strong and can damage the shingles by loosening their adhesive, forcing water underneath them, or causing them to fall off. The safer and better option is soft washing with a pump sprayer. For best results and to avoid damage, consider hiring a local roof cleaner to clean your shingles safely.

Hardscaping is made to withstand the elements, but it still needs regular cleaning as well as maintenance like weeding, replacing broken pieces, removing mold or mildew, and more. Use an appropriate cleaner for the hardscaping material with a stiff brush to remove dirt and other material, or use a pressure washer for a deep clean. Staying on top of maintenance can alert you to any problems with your hardscaping that will need repair or replacement.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.