Get matched with top drywall pros in Sangerville, ME

Certain drywall textures, like sand and sometimes popcorn, can be smoothed by applying skim coats, sanding the walls, or chipping away the texture. However, it’s worth considering removing the texture and starting with a blank canvas. Smoothing textured walls requires a lot of sandpaper and elbow grease and can take longer than just outright removing the texture.

Eco-friendly options reduce environmental impact and often improve indoor air quality.

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.

Drywall does not necessarily need to be glued to the ceiling, especially when it is properly screwed or nailed into place. Drywall is typically attached to the ceiling joists using screws or nails, ensuring a secure and stable drywall installation. 

However, in certain situations where additional adhesion is required, construction adhesive can be applied in combination with screws or nails. This is often done for ceilings with specific acoustic or insulation requirements. It's essential to follow local building codes and best practices to determine if adhesive use is necessary for your specific project.