Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Lochearn, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Lochearn, MD?

Select your specific project to find the pro for you.

TRUSTED BY LOCHEARN, MD HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon370
    Verified drywall insulation services reviews

Find Drywall insulation pros in Lochearn

Avatar for Koala Insulation of The Greater Baltimore Area
Koala Insulation of The Greater Baltimore Area
4.8(
13
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lochearn, MD and surrounding areas

Approved

In business since 2023

Free estimates

Warranties offered

"We had insulation installed a week earlier by Koala. During the insulation, Jasper (insulator) suggested another area that we might consider installing blown-in insulation. We agreed and the second job was performed on Friday, the 24th. Jasper and Richard were on time, the insulation project was well done and they left the area very clean. Would use them again."
Insulation Projects
Spray Foam Insulation
Insulation Projects
Blow-in Rig
Truck

+9

Response time8 hrs
1 neighbors recently requested a quote
Recommended by83%of homeowners
Avatar for RetroFoam of Philadelphia
RetroFoam of Philadelphia
5.0(
22
)
Injection Insulation - Install

Serving Lochearn, MD and surrounding areas

Approved (Corporate)

In business since 2023

Free estimates

Warranties offered

"We are extremely satisfied with the whole process of our house being insulated. First we had the walls done, and then a couple weeks later we had our attic insulated. The crew were so nice, friendly, and knowledgeable. We are very satisfied with everything. Thank you, everyone."
RetroFoam Wall Insulation
Installing RetroFoam
RetroFoam with Siding
RetroFoam with Brick
Response time1 day
Response rate100%
119 neighbors recently requested a quote
Avatar for Atlas Home Energy Solutions
Atlas Home Energy Solutions
4.1(
34
)
Blown-In Insulation - Install or Upgrade

Serving Lochearn, MD and surrounding areas

Approved

In business since 2009

Free estimates

Credit card accepted

"I hired Atlas Home Energy Solutions to remove old insulation and replace it with the foam technique. However, I ran into numerous unexpected problems due to a slow leak from old pipes. It took awhile to sort out. Atlas Home Energy Solutions gave me lots of expert advice. They were willing to come out and review the situation. They were also willing to reschedule and wait until another contractor dealt with the water issue and its ensuing problems. They helped me make some difficult decisions before they could insulate the crawl space. When it was ready for them to come and insulate the area they bumped their schedule forward to get it done. This company did sterling work. Their expertise and professionalism were outstanding. They really know what they are doing and guided me through a more protracted process than originally envisioned. I would highly recommend them to anyone."
Visual Inspection of all Areas of your Home
Attic Insulation and Air Sealing
Infrared Camera Inspection
Attic Spray Foam
Blower Door Whole House Air Leakage Test

+11

Response time1 day
Recommended by87%of homeowners
Avatar for Terra Insulation
Terra Insulation
4.4(
16
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lochearn, MD and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

"They took the time to explain the options and inform my decision-making. They answered all of my questions with patience and good humor. I believe I have received great value for the money I have spent. They were flexible when I wanted to make a change once work had begun. Since the house has been air sealed and insulated we have been warm and comfortable. I highly recommend Terra Insulation for your insulation needs."
R-49 Blown Fiberglass
Baffle Vents
Recessed Can Light Covera
Attic Penetrations- before air sealing
Air Sealing After

+1

Response time3 days
Response rate97%
2 neighbors recently requested a quote
Avatar for ROI Construction LLC
ROI Construction LLC
4.3(
17
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lochearn, MD and surrounding areas

Approved

In business since 1974

Free estimates

Warranties offered

"We had a great experience with ROI Construction sales representative David Burke. David was very knowledgeable about ROI's porducts and services. We look forward to getting our attic insulation project completed and will provide a more thorough review at that time. Thanks, Tim"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+19

52 neighbors recently requested a quote
Recommended by90%of homeowners
Avatar for Smart Energy Pros
Smart Energy Pros
4.3(
19
)
Blown-In Insulation - Install or Upgrade

Serving Lochearn, MD and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

"Brian came out to perform an energy audit on my home. He arrived on time, was respectful of my home and showed me where my insulation was missing with his infrared camera! His report came two days later as promised with a reasonable quote."
Energy Audit-Insulation
Energy Audit-Insulation
Energy Audit-Insulation
Energy Audit-Insulation
Energy Audit-Insulation

+8

Response time8 hrs
Response rate96%
4 neighbors recently requested a quote
Cameron Home Insulation
4.6(
40
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lochearn, MD and surrounding areas

In business since 1907

Free estimates

Credit card accepted

"Debbie, the AC&R salesperson, was very knowledgeable and confident. They were the 2nd quote I got for work and came in even lower than I expected (which gave me pause as a low bid is a red flag). But true to her word, they did the work professionally (mostly...see below) and promptly. While I had another company do the energy audit for the Pepco rebate, AC&R took over the work, did the blown fiberglass one day and the spray foam the next.



For the blown fiberglass in the attics above our additions, they added spray foam (from a can) around any gaps per the contract and foam board baffles at the soffits. The installer noted that all our soffits were blocked and the batting insulation was too wide for the rafter channels, so he leveled it out as best he could to ensure an even coating of blown insulation. At the end, he sealed up the gaps between the attic and our to-be-finished upstairs (cape cod style, so all one room).



For the spray foam insulation, the team came in the next day, and I had to be out of the house due to fumes. I did come back around noon as they expected to be done well before then. They didn't know I came in and I went to the back of the house to watch TV on my work break. The one annoyance was during their cleanup, one of the installers came down into our kitchen and then saw me. He said he was looking for a vacuum cleaner to clean the stairs. I told him don't worry about the carpet as it was getting pulled up, but this was the one piece of unprofessionalism I noted above. Contractors should NEVER use the homeowner's property; they should bring their own tools, including vacuums!



While the spray foam can get very messy, they kept the splatter mostly contained to inside the crawlspace, not the finished flooring. However, I was surprised that they didn't tape off the outlet covers or light switched. since the particles are so small, we're going to have to replace the switches/receptacles at our cost. Also, there was a storm door screen that wasn't covered and now needs cleaned. Basically, I think they should have taken more care in covering the very few items we left upstairs and the outlets/switches.



They didn't spray around the window frames (large gaps where window weights used to be) because the open cell foam would expand too much. If I wasn't there, I think they would have just left, but it was clear in our contract discussions they needed to insulate those spaces too. They used a few cans of "Good Stuff" equivalent, but didn't fill in the gaps entirely. It did the job well enough, but it's a ding against them as I expected more preparation.



Lastly, I thought that AC&R would walk me through all the scheduling and final "test out" (for the Pepco rebate), but I had to contact them and schedule with someone different each time. They were always prompt, but I expect the experts to know to do this for/with me rather than expect me to know the process. I go through it once in a lifetime while they do it weekly.



While the end of the review sounds more negative than positive, I would definitely recommend AC&R out to others as they're priced right, they have been in business for over a century, and like any contractor, you just need to follow up to be sure everything is done to your satisfaction.
"
Recommended by100%of homeowners
...
Showing 1-10 of 65
Drywall Insulation questions, answered by experts

White walls are the toughest color to keep clean and maintain, as they’re extremely unforgiving when it comes to dirt, splatters, dust, and smudges. Still, many people look past their high-maintenance requirements because they lighten and modernize a space beautifully. If you’re opting for white walls, it’s especially important to keep up with regular cleanings, so they stay pristine.

Yes, any parts of drywall that are wet or overly moist will need to be replaced. Drywall is intended to be dry (it’s in the name, after all.), as excess moisture can lead to mold and mildew and eventually corrode your home’s foundational building pieces. Do regular inspections in your home to make sure all your plumbing is intact and in good condition—this will go a long way toward preventing leaks.

Vinegar and bleach are effective options for removing mold from drywall. Vinegar is a better choice if you have a smaller mold issue while bleach is best if you have a larger mold problem. If the area you're cleaning has limited ventilation, using vinegar would be a better option. In that case, you could mix vinegar with baking soda to remove more stubborn mold growth.

Whether to repair or replace water-damaged plaster depends on the scale of the damage. For small, limited areas, you can often perform a repair yourself. If you choose to paint over small patches, ensure the surface is completely dry and apply a coat of antifungal primer first to prevent mold growth. However, simply painting or plastering over the damage is only a temporary solution that doesn't address the core problem. For more extensive or long-term damage, the plaster may be compromised, and there is a risk of mold. In these cases, it is recommended to remove the damaged section of plasterboard and replace it. You may consider hiring a professional for the repair, and it's worth noting that water damage is often covered by home insurance.

Drywall can be installed directly on ceiling joists. In fact, this method is common in many construction projects. Drywall sheets are attached to the joists using screws, ensuring a secure and stable installation. Before attaching the drywall, it's important to mark the joist locations on the ceiling, allowing for accurate screw placement. Proper spacing between screws and careful taping and mudding of joints are crucial to creating a smooth and flawless ceiling surface. If the joists are in good condition and level, installing drywall directly on them is a practical and efficient approach.

The Lochearn, MD homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.