Top-rated well and pump technicians.

Best well and pump technicians near Kettering, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Kettering, MD?

Select your specific project to find the pro for you.

TRUSTED BY KETTERING, MD HOMEOWNERS

  • Average homeowner rating star icon4.3
    Average homeowner rating
  • Verified reviews icon250
    Verified well and pump services reviews

Top-Rated Well and pump technicians in Kettering - Updated Nov 2026

Avatar for Sila Heating, Cooling and Plumbing
Sila Heating, Cooling and Plumbing
4.6(
2,180
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Kettering, MD and surrounding areas

In business since 1989

Free estimates

Emergency services offered

"One unit was fine. The heat pump unit needs some new parts as it is 11 years old and sitsc in the roof under the southern sun and is just getting worn down. So Rob from Sila recommended the parts that need replacing. Very good company that I have used for that to perform these twice yearly checkups. Highly recommended."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+4

Recommended by91%of homeowners
...
Showing 1-10 of 68
Wells and Pumps FAQs, answered by experts

If you have a small well or a particularly high water demand, it’s possible to overuse your well. How quickly a well replenishes depends on its water source. In this case, you may want to purchase a water storage tank that you can fill from the well in off-hours, or if you’re planning to build a new well and you expect a large water demand, you may want to build a deeper well to match your needs.

The average three to four-bedroom home typically uses a well pump rated for 8 to 12 gallons per minute (GPM). To find the most accurate size for your specific needs, a common rule of thumb is to count the number of water fixtures and appliances in your home and aim for that number in GPM. This calculation allows for about one gallon of water per minute per fixture. Because estimating the correct size can be challenging, it's best to have a professional technician make the final determination. A professional can ensure your pump provides sufficient water for your home, especially during peak usage hours.

A leaking well pipe is quite different from if the well itself is leaking. To seal a leaking well, pour a cement mixture or bentonite into the space between the well casing and the borehole wall. The heavier cement collects at the bottom to form a solid seal, pushing lighter materials like mud and fluids up toward the surface. Professional well installation companies have the equipment to do this properly. 

Why is my irrigation pump not pulling water?

There are a few reasons your irrigation pump isn’t pulling in water. You could have a clogged suction filter. You may have not properly primed your pump so air got stuck somewhere in the system. Your pump also won’t work properly if it has faulty or damaged pump components, like a pump motor or pressure switch.

A submersible pump should be at least 10 feet from the bottom of the well to minimize the risk of the pump drawing debris into the well water. Submersible pumps work best for wells that are 25 feet deep or less. If you have a deeper well, choose a jet pump instead of a submersible model.

The Kettering, MD homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.