Get matched with top pressure washers in Fulton, MD

The Centers for Disease Control and Prevention (CDC) recommends using an EPA-registered disinfectant product to disinfect a house properly. If such a product isn't handy, a strong bleach solution can disinfect high-touch surfaces. Before hiring a professional, be sure to discuss the type of chemicals and disinfectants they plan to use to ensure they’re safe for household use.

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

Yes, you must thoroughly clean your deck before staining. If you don't, dirt, debris, grease, and mildew can get trapped between the wood and the new stain. This not only looks unsightly but also prevents the stain from penetrating the wood properly, reducing its ability to protect the deck from weather and UV rays. As a result, the stain won't last as long or look as good. Any existing mold or mildew left untreated can continue to grow beneath the new stain, potentially leading to wood rot and structural damage. Always wait at least 48 hours after cleaning for the wood to dry completely before applying stain.

Brick takes longer to dry than less porous materials like concrete. If you are waiting to spot clean, a full day of mild weather should do the trick. If you are waiting to paint or apply a finish or sealant, give it three to four days to ensure the brick is absolutely dry as a bone. You don’t want any residual moisture whatsoever before laying down paint or sealant.