Get matched with top electricians in Catlettsburg, KY

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

The number of outlets and lights you can safely run on a single circuit depends on the circuit's amperage and local electrical codes. A general rule is to allow one outlet or light fixture per 1.5 amps, keeping the total load under 80% of the circuit breaker's capacity. For example, a 15-amp circuit can typically support up to eight outlets or lights, while a 20-amp circuit can accommodate up to ten. Always consider the combined power usage of all connected devices and fixtures to prevent overloading. For specific guidelines and to ensure safety, it is best to consult local electrical codes or a licensed electrician.

To reset an electric fireplace, first shut the unit off using the control panel or remote control. Make sure the unit is entirely shut down, then unplug it from the power outlet. Wait five to 10 minutes, then plug the fireplace back in and turn it on. This process should reset the electric fireplace. After resetting, make sure to set the thermostat, timer, and other programmable settings to suit your preferences.

Yes, the National Electrical Code reviews household codes every three years. However, that doesn’t always mean that kitchen counter outlet requirements will change, but it does allow room for professionals to make updates. That’s why many older kitchens are no longer code-compliant thanks to changing rules for amperage, GFCI protection, and more.