Get matched with top roofers in Vandalia, IL

The lifespan of a torch down roof depends on the number of layers installed. A single-ply system typically lasts between 10 and 15 years, while a multi-layer system with two or three layers can last from 15 to 25 years. Although a multi-layer option may be more expensive upfront, it provides a longer service life. Warranties often reflect this, with about 12 years for a one-ply system and 15 years for a two-ply system. For context, this lifespan is shorter than other common roofing materials like wood or asphalt shingles, which typically last 20 to 30 years, with high-quality versions lasting up to 50 years.

As with any roofing material, there are benefits and drawbacks to consider before installing roll roofing. On the plus side, roll roofing is budget-friendly, lightweight, and comparatively easy to install. It is also ideal for low-sloped roofs and lasts around 10 years. The cons of roll roofing, however, include its low durability compared to roofing materials, restricted color choices, and low ROI.

Pros:

• Low-cost

• Lightweight

• Cut to size

• Easy and quick installation 

• Designed for low-sloped roofs

• Waterproofs your roof for an average of 10 years

• Easy to purchase and transport

Cons:

• Less durable than asphalt shingles

• More prone to cracks and tears

• Short life span

• Not as many color or style choices

• Not as aesthetically pleasing as shingles, wood, or clay tiles

• Not preferred for a higher home resale value

You shouldn’t put a new roof underlayment over an old one for a few reasons. Old felt must be removed in order to assess the condition of your roof decking, such as rotting wood or other structural issues. Also, if your roofer doesn't install a fresh layer of felt as is required by shingle manufacturers, your warranty may be voided. Finally, old underlayment removal is often included in the cost of roof repair or replacement, so there's no real benefit to leaving it on before installing a new layer.

Some people prefer to use connectors consisting of galvanized metal to replace the birdsmouth cuts on the rafter board. Common names for these metal pieces include hurricane ties and variable-pitch connectors. Making birdsmouth cuts is more cost-effective than purchasing these connectors for each rafter. However, because making large birdsmouth cuts to accommodate extra-wide exterior walls can weaken the rafter, a connector may be the better option in some cases.