Get matched with top roofers in Witt, IL

It’s the reverse of home de-winterization. To winterize, you purge your plumbing system (including your water heater and all piping) of water. Some experts also recommend filling fixtures with an antifreeze solution. Other tasks involve winterizing sprinklers, sealing foundation vents, check weatherproofing around doors and windows, and more.

Just like when you’re shingling a roof, you can install felt underlayment under a metal roof, but a synthetic underlayment like adhered ice and water shield is the best option. These use adhesives rather than mechanical fasteners, so you have fewer penetrations going through your roof deck and a lower risk of leaks. Ice and water shield is also easier to install because you don’t need additional tools or fasteners to attach it to the roof deck.

A chimney cap costs about $300 on average to install, with prices ranging from $75 to $1,000. The final cost depends on several factors, including the professional you hire, the accessibility of your chimney, the cap's material and size, whether any repairs are needed, and if it requires custom fabrication. Chimney caps are usually made from galvanized steel, stainless steel, or copper. Copper caps are the most expensive, followed by stainless steel and then galvanized steel. Excluding labor, average material costs are around $100 for galvanized steel, $250 for stainless steel, and $600 for copper. You may also face additional costs, such as hiring a chimney sweep to clean the chimney before the cap is installed.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.