Get matched with top pool and spa technicians in Savanna, IL

Follow these general safety tips for spas and hot tubs:

• Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

• Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

• Don’t use the hot tub or your pool during a thunderstorm. 

• Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

Most newer hot tubs are not expensive to maintain. Hot tub maintenance costs about $500 to $1,000 per year. You can DIY, but a pro can clean and treat your hot tub with chemicals and save you time. The biggest hot tub expenses are heating and repairs, but you can preserve your investment with regular maintenance.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

Vinegar can be used as an all-purpose cleaner for many things, including hot tub filters. Soaking hot tub filters in vinegar and water for up to 24 hours can remove dirt and oil, and as a bonus, it won’t cause the water to foam after you reinstall it if there’s vinegar left on it. But make sure you still rinse it to remove any debris, dirt, or grime stuck on it.