Get matched with top foundation drain installation pros in Moro, IL

Not all window wells have a formal drain, but they all require a method for water to flow away from the window. Some wells are connected to an interior or exterior drain tile, which is the most effective solution. Others rely on a deep layer of gravel or crushed stone that allows water to filter down into the soil.

However, if a window well lacks a proper drainage system, it can lead to basement seepage, costly water damage, mold growth, and potential foundation damage. This is especially true in areas with heavy rainfall or expansive soil.

If your window well doesn't have a drain or is not draining quickly enough, you have a few options. For gravel-based systems, the stone may have compacted and needs to be improved. For a more robust solution, you can hire a plumber or window installer to connect the well to a drainage system. This can also be a DIY project using a shovel or auger.

Yes, you can finish a basement that leaks, as long as you address the leak first. Before finishing a basement, you’ll need to repair any cracks in the walls and waterproof the basement to prevent future leaks. It’s much harder to clean up a water leak from a finished basement than an unfinished one, so preemptively addressing any leaking areas prevents expensive repairs in the future.

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.

A small sump pump running infrequently uses an average of 10 kilowatt-hours (kWh) of electricity per month. The average cost for electricity is $0.171 per kWh. The size and use frequency affect how much electricity it uses. Sump pumps average one-third to one horsepower (hp) motors. One hp is equal to 745.7 watts. Watts multiplied by the time your pump is running divided by 1,000 equals your average kWh. Multiply kWh by your average cost of electricity. In areas with high rain or a marsh basin, the average cost can be as high as $15-$25 a month.