Best water heater pros near Brookfield, IL

Yes, this would be an appropriate choice. In order to comply with the National Electric Code’s rules, you'll need to install a circuit breaker that's 125% larger than the intended load. In this case, you'll multiply 30 amps by 1.25 to find the necessary breaker size. Plugging that equation in for your 30-amp water heater will leave you with a 37.6-amp breaker. If your current water heater keeps tripping the breaker, it might be time to talk to a plumber or electrician about upgrading your water heater's setup.

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

If you're replacing a broken water heater, now is a great time to make sure you're selecting a unit that has the right capacity for your household. According to the U.S. Department of Energy, a small 50-gallon to 60-gallon tank is sufficient for households with one to three people. A medium-sized 80-gallon tank is considered ideal for three to four people. A larger tank may be needed if your household has four to six people.

Every type of water heater has its advantages and disadvantages. Understanding those can help you decide the best type for your situation and budget. 

Pros

• Safer than gas or propane

• Doesn’t require extensive venting systems

• Lower upfront costs

• Simpler to operate

• No pilot light

• Easier installation

• More efficient heating than gas models

• Available as point-of-use (POU) and whole-house units

Cons

• Slower to heat water

• Longer recovery time

• Possibly higher operating costs

• Doesn’t work during a power outage

• Costs can increase without a 240-volt connection