Get matched with top septic tank pros in Anna, IL

The size of your water well pressure tank is limited only by your budget and the amount of space you have to use. Larger tanks can hold more water, meaning your well pump will need to cycle less often. This can extend the life of both the pressure tank and your well pump. Larger tanks cost more and take up more room, though.

There are a couple of ways you can determine the depth of your well. One method is to use a device called a well sounder. This tool has a long measuring tape containing a sensor to alert you once the end reaches the water. 

Or you can DIY it by using a long tape measure with a half-filled bottle of water attached to it. Lower the tape measure into your well. Once you feel tension on the tape, you’ll know the bottle has reached your static water level. This will give you an approximate idea of your well’s depth.

Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.

A septic tank riser features a base ring that you need to install flush to the opening of the septic tank. After thoroughly cleaning the opening of the tank, fit the base ring over the opening and use a butyl sealant rope to create an airtight seal with the tank’s rim. Cut the riser rings to the appropriate height and stack them on the base ring. Then, install the riser lid. This task might be taken on by an experienced DIYer, but you should always call a septic tank professional if you are unsure of your skills.