Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Roberts, ID

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Roberts, ID?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Roberts

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Roberts, ID and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools questions, answered by experts

Yes, you can use food coloring to find a pool leak. Alternatively, you can use pool detection dyes that are nontoxic and biodegradable. Depending on how much food dye you have on hand, it may be more cost-effective to use pool dyes.

The dye test is one of the best swimming pool leak detection tools because the dyes are heavier than water. By observing where the dye gets sucked in, you can find the location of your leak.

Setting up a pool on unlevel ground is not recommended as it can damage the pool or yard and put the safety of those using it at risk. If a pool isn't level, the water's weight won't distribute evenly, putting excessive pressure on certain parts. This can cause the pool liner to tear or the walls to collapse, leading to water damage, expensive repairs, or potential injury to swimmers. It is more cost-effective to level the ground correctly before installation rather than waiting to address serious structural issues later.

Yes, too much chlorine can make your pool cloudy, especially after you have recently shocked it. However, low chlorine levels are a more common cause of cloudy water. An imbalance in pH or an excess of any chemical can also lead to cloudiness. To determine the specific cause, you should test your pool water to check the levels of chlorine, pH, and other chemicals. Regular maintenance is essential for keeping your pool clean and clear.

Factors affecting pool installation costs include pool size, construction material, special features (like lighting or waterfalls), landscaping, and prevailing site conditions, which might enhance excavation complexity.

A few factors influence the time it takes for a pool to heat up, including the size of your pool, the temperature outside, and how much direct sunlight is hitting the water in the pool. With these factors in mind, it takes 12 to 72 hours to raise the temperature in a pool by 20 degrees Fahrenheit.

While you can run a pool heater all day, it is advised only to run it during the day, as it is more energy efficient. At night, it is better to purchase a solar pool cover to retain the heat within the pool.

The Roberts, ID homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.