Get matched with top woodworkers in Marsing, ID

There are two ways you can cut trim for doorways: with a miter saw or a table saw. Mitered joints need a 45-degree angle. If you’re unfamiliar with a miter saw, you might want to consider buying extra trim pieces or choosing butted joints instead. One wrong cut, and you’ll need to power up the saw again with a new piece. 

Butted joints—also called shaker style—don’t need a 45-degree angle. Instead, your side pieces attach perpendicularly to the header trim and only require a straight cut.

Yes, carpenters can fix squeaky floors. They have the expertise to identify the source of the squeak, whether it’s loose floorboards, subfloor issues, or joist problems. These experts also have the right tools and hands-on knowledge to secure the flooring and eliminate the noise, ensuring a long-lasting solution.

If you’re just replacing a few broken or damaged joists, you can expect to pay anywhere from $100 to $300 per joist. However, a complete installation for a home or room will take into account the cost of labor, which ranges from $25 to $40 per hour. Floor joist installation for an entire room, for example, can cost between $5,000 and $10,000, depending on the room's size and the materials used.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.