"Very prompt. Ryler Henderson even a little bit early and came prepared. He did have to run get a few supplies, but was back extremely fast and had my whole job done. Start to finish in less than two hours. Professional work is exactly what exact exactly what was required on our appraisal report. Very personable and good communication skills and conversations skills. I would highly recommend him!"
"The problem turned out to be a burned out small electric door switch. I believe the price was way too expensive for the service performed and the price of the door switch. What more can I say? It got done."
Romes Electric, we proudly serve Cassia County and the surrounding communities with dependable, high-quality electrical services. From small repairs to complete installations, we specialize in all aspects of electrical work and take pride in doing the job right the first time. We combine friendly service, expert workmanship, and attention to detail to ensure results you can trust.
"I just moved into an antique house and was nervous about all things electric. They in and were very professional and thorough. Walked me through everything and eased my worries. Would 10/10 recommend."
"It went well he took time to position the light and move it around to make sure that it provided me with good coverage for the work area I needed it in."
An average, 400-square-foot electric heated driveways consume approximately $3 per hour in terms of electricity. The price may slightly fluctuate depending on your local energy cost. A simple formula to calculate your heated driveway’s total wattage consumption is by multiplying the square footage by 50 watts and then dividing it by 1,000 to get the kilowatt number. Multiply that with your local energy cost per hour and there you have the hourly operating cost.
No, wiring does not need to be redone to get a dimmer switch, as they work with single-pole and three-way switches. Just ensure you choose a dimmer that is compatible with your wiring, fixture, and lightbulbs. Most homes built after 1985 have neutral wiring and work with almost all dimmers. If your home was built before 1985 and you don’t have an updated electrical system, you may have to use a non-neutral wiring dimmer.
You will need a permit for any electrical work that involves installing or replacing wiring, moving or installing new fixtures, switches, or outlets, hardwiring appliances or HVAC equipment, installing subpanels, and upgrading electrical service. You typically don’t need a permit to have an electrician replace an existing light fixture or electrical box. You can always call your local building department to see if your project needs a permit, but a professional electrician will be able to tell you. In most cases, your professional will pull the permits for you.
To avoid drilling into wire, you will need to trace your home's wiring using a stud finder, wire detector, circuit tracer, or voltage finder. Since locating wires in your home can be difficult for some homeowners, hire a professional electrician with the experience and knowledge needed to safely handle electrical systems before drilling into any walls in your home.
Yes, you should get a quote or an estimate from an electrician. Most electricians offer free estimates or quotes. When getting quotes, do your research and verify each electrician’s license. Get quotes from three different electricians to compare. If the prices or items listed appear different on the quotes, ask the electrician to clarify. Learning as much as you can about the electrical work you want done will help you get the most accurate estimate.
The Broadford, ID homeowners’ guide to electrical services
From average costs to expert advice, get all the answers you need to get your job done.
Before you hire a licensed electrical contractor, you should learn the cost to run electric from the road to your house so you can budget for the project.
Is it time to upgrade your electrical panel? For the sake of safety, find out sooner than later by exploring our top signs that it’s time for an upgrade.
