Best toilet pros near Monroe, IA

The main cause of bathroom leaks is seals and connectors that loosen or deteriorate over time, causing leaks to develop. It's important to stay on top of your bathroom materials, as toilets, showers, and sinks all have different lifespans. Toilets and faucets last between 10 and 15 years on average with regular maintenance, but different parts may have shorter lifespans than others.

While gasket-sealed PVC flanges are the type most commonly found in homes, flanges come in a range of different materials, including copper, brass, stainless steel, cast iron, and aluminum, that pros sometimes secure with glue. If this is the case in your bathroom, the replacement is a job better left to the pros.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

If you’ve accessed the bolts and nuts that hold your toilet seat in place and can’t unscrew them, it’s possible that they were overtightened or that the material corroded over time, making it impossible to unscrew. If that’s the case, you can either call in a plumber for help, or you can DIY a solution if you’re careful. Lay down masking tape around the mounting bracket and then use the tape as a surface to lay a hack saw blade. Move slowly to cut through the bracket and bolt, being careful not to damage the porcelain in the process.