Get matched with top pool and spa technicians in Waynesboro, GA

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

The average life expectancy of a hot tub cover is between five and seven years. You can extend the life of yours by keeping it clean, using a soft cloth and mild dish soap; applying a vinyl protectant spray; using a cover lift to move and fold the cover carefully, rather than treating it roughly; protecting it from harsh weather; keeping kids and pets off the cover; and cleaning the underside of the cover with a chlorine spray. Investing in a quality cover will also help it last longer and look better.

Follow these general safety tips for spas and hot tubs:

• Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

• Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

• Don’t use the hot tub or your pool during a thunderstorm. 

• Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes.