Get matched with top concrete resurfacing pros in Micanopy, FL

Concrete resurfacing is the process of applying a new, thin layer of concrete over an existing concrete slab to enhance its appearance and durability. The terms 'concrete resurfacing' and 'concrete overlay' are often used interchangeably, though the exact meaning can vary between contractors. Generally, both refer to applying a layer of pre-blended concrete, typically between 1/4-inch and 1-inch thick. Some contractors may use 'overlay' to describe a thicker application that adds structural integrity, while 'resurfacing' might refer to a thinner, more cosmetic layer. This process is a cost-effective alternative to completely replacing the concrete, as it uses significantly less material than pouring a new 4-inch slab. Resurfacing also provides an opportunity to add new colors or stamped textures. Other names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

Concrete contractors typically charge anywhere from $6 to $14 per square foot. Cost factors include job size, site prep, base material, accessibility, your location, concrete finish, and concrete thickness. Removal of existing concrete, asphalt, deck, pavers, and grass will cost anywhere from $1 to $6 per square foot. Homeowners can often save money by removing and disposing of existing pavers, decks, and grass. Breaking up and hauling away concrete and asphalt is difficult and time-consuming without the proper equipment and may be worth having the pros do that work.

There’s no legal requirement that states that you need rebar in a concrete driveway, but since the slab will be supporting heavy vehicle loads, it’s always a good idea to pay a bit more for rebar reinforcement. Your driveway will be much more likely to crack if you don’t reinforce it with rebar. Driveways that need to support commercial vehicles or provide parking for multiple vehicles at once should always include rebar reinforcement. If you’re pouring concrete over asphalt or pouring concrete over an existing slab, you may not have enough depth for rebar, meaning an increased risk of cracking.

Self-leveling concrete is the best option for your garage floor since it guarantees an even surface in the end. However, most garage floors weren’t made with self-leveling concrete. You don’t need to fully replace the garage floor to use self-leveling concrete. A quarter-to-half-inch of self-leveling concrete on top of your existing floor will be sufficient for a smooth and even finish.