Top-rated paving pros.

Best paving pros near Ridgway, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your paving service project in Ridgway, CO?

Select your specific project to find the pro for you.

Top-Rated Paving pros in Ridgway - Updated Nov 2026

Avatar for R&R Masonry
R&R Masonry
4.5(
21
)
Interlocking Pavers for Patios, Walks & Steps - Install

Serving Ridgway, CO and surrounding areas

In business since 2015

Free estimates

"R&R repaired brick work around our garage and multiple pillars along our fence line. They were professional, reliable and did excellent work. Would readily recommend and hire again."
Stone Columns
Stone columns
Brick Work
House Siding
stone wall

+53

Response time1 day
Recommended by94%of homeowners
Showing 1-10 of 35
Paving Services FAQs, answered by experts

If you wish to break up a cracked or broken paver for removal, you can use a hammer or mallet and a chisel to fragment the paver. As you’re working, be careful not to disturb surrounding pavers; the key is to work slowly and steadily and remove the broken pieces gently. You should also wear a mask and goggles to ensure that no dust gets into your eyes, nose, or mouth as you work.

In most cases, you don’t need a permit to repave your driveway, although some exceptions exist. If you’re widening your driveway and plan on widening the apron as well, you’ll usually need a permit from the Department of Transportation in your area. This permit costs between $50 and $300 in most cases. Most municipalities will also require a certified and insured contractor do the work relating to the apron and curb cut. You can contact your building department or ask your paving company if you need a permit. Your driveway professional will usually pull the permit for you.

The layer of polymeric sand under the pavers plus the polymeric sand that gets swept into the joints between your pavers holds them in place in a few ways. For one, the gritty texture of the sand helps lock the pavers together. Polymeric sand also contains bonding agents that get activated by water. Polymeric sand will take between 24 and 48 hours to fully cure, so do not walk on your paver walkway before this time.

While blacktop is a type of asphalt, the terms should not be used interchangeably, as not all asphalt qualifies as blacktop. The primary differences are in their composition, production process, and ideal applications. Blacktop contains more stone than other types of asphalt and is heated to a higher temperature during production—300°F or more—while hot-mix asphalt is heated to between 275°F and 300°F. The ratio of bitumen (a tar-like crude oil) is a key differentiator, though sources vary: some state blacktop has less bitumen, making it less durable, while others claim it has a higher ratio. Due to these differences, asphalt is generally more durable and better for high-traffic areas like highways and streets, while blacktop is more suitable for playgrounds and residential driveways. For a driveway project, it is best to consult a professional to determine the most appropriate material.

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

The Ridgway, CO homeowners’ guide to paving services

From average costs to expert advice, get all the answers you need to get your job done.