Get matched with top fencing pros in Newcastle, CA

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

Removing fence posts that are set in concrete is something you can't do by hand. You will need an excavator, a strong post-puller, or a jackhammer. If you plan on recycling the concrete base, you may be able to cut the post out with a jackhammer and then set the new post in the existing base. However, it's usually better to remove both the fence post and concrete together. Due to the weight of concrete, you will need a hydraulic removal tool.

Yes, fence posts should be set in concrete to provide the proper support for the fence. If you notice your fence posts leaning, you’ll need to learn how to brace a fence post to fix the problem and prevent further damage from occurring. By bracing a fence post properly, you’ll provide stability and sturdiness to your fence for years to come.

The maximum recommended slope on which you can build a racked or stepped fence is 45 degrees. After that, construction becomes quite tricky and may require the use of retaining walls or terraces to make the fenced area flatter.